Fitting
KEVLAR BALLISTIC TOUR SERIES FAIRWAY
Elastically Tailored Composites
PURE KINETIC ENERGY
Wound…Round…Epic…
Wound for an explosive transfer of kinetic energy….however you drive it, KINETIXX® IMRT will optimize down range distance and target performance.
An active shaft that increases in frequency the greater the force applied.
This hard kicking, elastically tailored composite is engineered to improve club forgiveness and generate outrageous ball speed and precise shot control!
Technology/Design
Filament wound Vacuum Cured Construction technology produces round, pre-loaded concentric and spineless golf shafts for incomparable stability, dynamic response and feedback.
Kevlar Ballistic Tour series is Designed for strong players, desiring optimum control and a lower more penetrating incomparable Ballistic shot trajectory, from all fairway clubhead Systems.
Tension tailored for torsional recovery and attenuation of vibration, for the purest kinetic energy transfer from shaft to clubhead.
PADERSON® KINETIXX® loaded kevlar BALLISTIC series features the worlds only continuous fiber filament wound kevlar construction technology.
Optimizing the extraordinary material properties of Kevlar to create shafts with an incredibly high tensile strength-to-weight ratio; 5x stronger than steel, with 20x the elastic strength.
KGTP85-F is a Mid Balance, Mid kick point advanced composite shaft pre-loaded with a visible fiber structural grid Engineered according to each flex, for balanced strength and stability from butt to tip, without compromising feel.
Installation Guidelines
Installation Guidelines PADERSON KINETIXX LOADED shafts:
Installation should only be completed by a qualified, trained club builder.
- All PADERSON KINETIXx loaded shafts are to be BUTT Cut to length only.
- Do not TIP trim any shaft model! Regardless of CPM, or club assembly config.
- Please do not Chamfer the tips however light belt abrasion is recommended.
*Tip preparation: light belt abrasion or hand sanding recommended prior to final assembly.
*To ensure a smooth and clean build, we perform a post-production tip preparation: 1″ Metalwoods, 1.25″ Irons. depending on hosel bore depth, there will in many assemblies be the need to lightly sand beyond the prepared surface delivered. Light belt abrasion is also recommended to insure a full shaft insert and adequate epoxy adhesion. Do not Chamfer tip section or blade prep (scratch) tip to prepare for epoxy.
Reviews
There are no reviews yet.